candence 阻抗匹配设定
IMPEDANCE_RULE
The IMPEDANCE_RULE property, attached to a net, specifies an impedance restriction between any two pins on a net or between any pin and Tpoint connection on a net. This property is used by DRC checking and routing.
If a connection has an impedance constraint specified by both an IMPEDANCE_RULE property and an electrical constraint set, the IMPEDANCE_RULE value is used. Use Constraint Manager for pin-pairs.
The format of the IMPEDANCE_RULE property in the $A_PROPERTIES section of a netlist is
- IMPEDANCE_RULE{ALL:ALL:impedance:tolerance:}... ; netname=A:B:C:D
- A:起点
- B:终点
- C:阻抗大小
- D:阻抗的误差大小
Specifies the checking of impedance of everyconnect line (cline) segment in the net. | ||
Required. Specifies the impedance constraint value in ohmsexpressed as a decimal number. | ||
Specifies the tolerance for an impedance value specified either as avalue in ohms or a percentage. You must follow a percentage with a % (percent sign). If you do not specify a value, 2% is assumed. | ||
Specifies the name of the net to which the impedance applies. |
![](https://images2017.cnblogs.com/blog/882870/201710/882870-20171025091310660-1912332993.png)
![](https://images2017.cnblogs.com/blog/882870/201710/882870-20171025091311238-87508725.png)
![](https://images2017.cnblogs.com/blog/882870/201710/882870-20171025091312660-1256997831.png)
![](https://images2017.cnblogs.com/blog/882870/201710/882870-20171025091312988-835658031.png)
![](https://images2017.cnblogs.com/blog/882870/201710/882870-20171025091313379-455825729.png)
![](https://images2017.cnblogs.com/blog/882870/201710/882870-20171025091314551-179393577.png)
![](https://images2017.cnblogs.com/blog/882870/201710/882870-20171025091314863-1871653263.png)
![](https://images2017.cnblogs.com/blog/882870/201710/882870-20171025091315379-692508037.png)