linux驱动- PCI-E设备驱动-PCIE设备结构体

/*
* The pci_dev structure is used to describe PCI devices.
*/
struct pci_dev {
    struct list_head bus_list;/* node in per-bus list */
    struct pci_bus *bus;/* bus this device is on */
    struct pci_bus *subordinate;/* bus this device bridges to */
     
    void*sysdata;/* hook for sys-specific extension */
    struct proc_dir_entry *procent;/* device entry in /proc/bus/pci */
    struct pci_slot *slot;/* Physical slot this device is in */
     
    unsignedint devfn;/* encoded device & function index */
    unsignedshort vendor;
    unsignedshort device;
    unsignedshort subsystem_vendor;
    unsignedshort subsystem_device;
    unsignedintclass;/* 3 bytes: (base,sub,prog-if) */
    u8 revision;/* PCI revision, low byte of class word */
    u8 hdr_type;/* PCI header type (`multi' flag masked out) */
    u8 pcie_cap;/* PCI-E capability offset */
    u8 pcie_type;/* PCI-E device/port type */
    u8 rom_base_reg;/* which config register controls the ROM */
    u8 pin;/* which interrupt pin this device uses */
     
    struct pci_driver *driver;/* which driver has allocated this device */
    u64 dma_mask;/* Mask of the bits of bus address this
    device implements. Normally this is
    0xffffffff. You only need to change
    this if your device has broken DMA
    or supports 64-bit transfers. */
     
    struct device_dma_parameters dma_parms;
     
    pci_power_t current_state;/* Current operating state. In ACPI-speak,
    this is D0-D3, D0 being fully functional,
    and D3 being off. */
    int pm_cap;/* PM capability offset in the
    configuration space */
    unsignedint pme_support:5;/* Bitmask of states from which PME#
    can be generated */
    unsignedint pme_interrupt:1;
    unsignedint d1_support:1;/* Low power state D1 is supported */
    unsignedint d2_support:1;/* Low power state D2 is supported */
    unsignedint no_d1d2:1;/* Only allow D0 and D3 */
    unsignedint mmio_always_on:1;/* disallow turning off io/mem
    decoding during bar sizing */
    unsignedint wakeup_prepared:1;
    unsignedint d3_delay;/* D3->D0 transition time in ms */
     
    #ifdef CONFIG_PCIEASPM
    struct pcie_link_state *link_state;/* ASPM link state. */
    #endif
     
    pci_channel_state_t error_state;/* current connectivity state */
    struct device dev;/* Generic device interface */
     
    int cfg_size;/* Size of configuration space */
     
    /*
    * Instead of touching interrupt line and base address registers  使用储存在irq的值取代直接接触中断线和基地址寄存器。
    * directly, use the values stored here. They might be different!
    */
    unsignedint irq;
    struct resource resource[DEVICE_COUNT_RESOURCE];/* I/O and memory regions + expansion ROMs */
    resource_size_t fw_addr[DEVICE_COUNT_RESOURCE];/* FW-assigned addr */
     
    /* These fields are used by common fixups */
    unsignedint transparent:1;/* Transparent PCI bridge */
    unsignedint multifunction:1;/* Part of multi-function device */
    /* keep track of device state */
    unsignedint is_added:1;
    unsignedint is_busmaster:1;/* device is busmaster */
    unsignedint no_msi:1;/* device may not use msi */
    unsignedint block_ucfg_access:1;/* userspace config space access is blocked */
    unsignedint broken_parity_status:1;/* Device generates false positive parity */
    unsignedint irq_reroute_variant:2;/* device needs IRQ rerouting variant */
    unsignedint msi_enabled:1;
    unsignedint msix_enabled:1;
    unsignedint ari_enabled:1;/* ARI forwarding */
    unsignedint is_managed:1;
    unsignedint is_pcie:1;/* Obsolete. Will be removed.
    Use pci_is_pcie() instead */
    unsignedint needs_freset:1;/* Dev requires fundamental reset */
    unsignedint state_saved:1;
    unsignedint is_physfn:1;
    unsignedint is_virtfn:1;
    unsignedint reset_fn:1;
    unsignedint is_hotplug_bridge:1;
    unsignedint __aer_firmware_first_valid:1;
    unsignedint __aer_firmware_first:1;
    pci_dev_flags_t dev_flags;
    atomic_t enable_cnt;/* pci_enable_device has been called */
     
    u32 saved_config_space[16];/* config space saved at suspend time */
    struct hlist_head saved_cap_space;
    struct bin_attribute *rom_attr;/* attribute descriptor for sysfs ROM entry */
    int rom_attr_enabled;/* has display of the rom attribute been enabled? */
    struct bin_attribute *res_attr[DEVICE_COUNT_RESOURCE];/* sysfs file for resources */
    struct bin_attribute *res_attr_wc[DEVICE_COUNT_RESOURCE];/* sysfs file for WC mapping of resources */
    #ifdef CONFIG_PCI_MSI
    struct list_head msi_list;
    #endif
    struct pci_vpd *vpd;
    #ifdef CONFIG_PCI_IOV
    union{
    struct pci_sriov *sriov;/* SR-IOV capability related */
    struct pci_dev *physfn;/* the PF this VF is associated with */
    };
    struct pci_ats *ats;/* Address Translation Service */
    #endif
};

 

posted @ 2016-12-21 10:10  星星stars  阅读(4731)  评论(0编辑  收藏  举报