Arduino 3g shield using GSM bought from ITead

This is an old arduino 3G module bought half years ago.

Its wiki:

http://wiki.iteadstudio.com/ITEAD_3G_Shield

Its mall:

http://imall.itead.cc/itead-3g-shield.html

But as you can see that, the download link does not exist anymore. But after googling a bit, there are some alternatives for you to download the goodies.

Datasheet for ITEAD 3G Shield http://pan.baidu.com/s/1ntCH4UH

Schematic for ITEAD 3G Shield http://pan.baidu.com/s/1pJ5lRzt

Demo Code for ITEAD 3G Shield http://pan.baidu.com/s/1gdyaCYf

Its back where you insert a SIM card:

On arduino, switch VCC to 5V, switch Flight mode , RF to be On.

And for the UART multiplexer on the board,

When using the connection as Figure 4, the SIM900 connect to the ATMega328 chip on board.

Pin D0 Tx on 3G shield <-----> Rx on Arduino

Pin D1 Rx on 3G shield <-----> Tx on Arduino

To test whether your board is working:

void setup()
{
  Serial.begin(115200);
}

void loop()
{
  while(1)

  {
    // dail 13988899999
  Serial.print("ATD13988899999;\r");
  
  delay(5000); 
  }

}

This is gonna dial this number 13988899999 forever.

If you receive a call, your module is working perfectly.

This board uses AT commands to control itself.

Key: AT commands

What is AT commands?

For Chinese readers: http://baike.baidu.com/view/2420376.htm

For English readers: https://en.wikipedia.org/wiki/Motorola_phone_AT_commands ( This is very helpful )

The AT commands manual those are compatible for this board can be found here.

http://wiki.iteadstudio.com/images/2/20/SIM5215J_SIM5216J_AT_Command_Manual_V1.02.pdf

Or here: http://pan.baidu.com/s/1kDDQu (You do not need to be an expert)

It looks the manual is long enough to make you sleepy. :P Just check the exquisite down below.

You can find helpful tutorials from Arduino offcial forum:

http://forum.arduino.cc/index.php?topic=140526.0

And the problem was solved. You can use that scope of codes.

Setting the UART multiplexer

If you do not know anything about UART multiplexer, you could check it out here. http://wiki.iteadstudio.com/IComSat

From its schema:

It looks like this:

Play with the jumpers on the board.

It would looks like this before:

then re-set it to be like this:

Now you program on it.

Let's try some AT commands:

Send command:

ATI

You would get these in return:

ATI

Manufacturer: SIMCOM INCORPORATED
Model: SIMCOM_SIM5216E
Revision: SIM5216E_V1.5
IMEI: 359769033240570
+GCAP: +CGSM,+DS,+ES

OK

To the UART SoftwareSerial ports.

If you want to debug this 3G shield module with arduino, PC , you should set baud rate to be 9600 or less.

The rate of 115200 is too high for SoftwareSerial on Arduino. ( That's why here later I used a FT232 USB2Serial module on PC to communicate with this 3G shield without arduino. )

It looks as what he said: http://forum.arduino.cc/index.php?topic=140526.msg1653999#msg1653999