RPI学习--wiringPi_setups

reference: http://wiringpi.com/reference/setup/

 

There are four ways to initialise wiringPi.

wiringPi库提供了四种方法（函数）用来初始化wiringPi。

• int wiringPiSetup (void) ;
  
• int wiringPiSetupGpio (void) ;
  
• int wiringPiSetupPhys (void) ;
• int wiringPiSetupSys (void) ;

One of the setup functions must be called at the start of your program or your program will fail to work correctly. You may experience symptoms from it simply not working to segfaults and timing issues.

当你编程的时候必须在开头调用这四个设置函数中的一个，否则你的程序将运行不了。你可能经历过像简单的不能工作，段错误，定时问题这样的一些症状。

 

Note: wiringPi version 1 returned an error code if these functions failed for whatever reason. Version 2 returns always returns zero. After discussions and inspection of many programs written by users of wiringPi and observing that many people don’t bother checking the return code, I took the stance that should one of the wiringPi setup functions fail, then it would be considered a fatal program fault and the program execution will be terminated at that point with an error message printed on the terminal.

注意：对于wiringPi 的V1版本，如果这些设置函数调用失败，不管什么原因，它将会返回一个错误代码。

• If you want to restore the v1 behaviour, then you need to set the environment variable: WIRINGPI_CODES (to any value, it just needs to exist)

The differences between the setup functions are as follows:

• wiringPiSetup (void) ;
  

This initialises wiringPi and assumes that the calling program is going to be using thewiringPi pin numbering scheme. This is a simplified numbering scheme which provides a mapping from virtual pin numbers 0 through 16 to the real underlying Broadcom GPIO pin numbers. See the pins page for a table which maps the wiringPi pin number to the Broadcom GPIO pin number to the physical location on the edge connector.

This function needs to be called with root privileges.

• wiringPiSetupGpio (void) ;
  

This is identical to above, however it allows the calling programs to use the Broadcom GPIO pin numbers directly with no re-mapping.

As above, this function needs to be called with root privileges, and note that some pins are different from revision 1 to revision 2 boards.

• wiringPiSetupPhys (void) ;

Identical to above, however it allows the calling programs to use the physical pin numberson the P1 connector only.

As above, this function needs to be called with root priviliges.

• wiringPiSetupSys (void) ;
  

This initialises wiringPi but uses the /sys/class/gpio interface rather than accessing the hardware directly. This can be called as a non-root user provided the GPIO pins have been exported before-hand using the gpio program. Pin numbering in this mode is the native Broadcom GPIO numbers – the same as wiringPiSetupGpio() above, so be aware of the differences between Rev 1 and Rev 2 boards.

Note: In this mode you can only use the pins which have been exported via the /sys/class/gpio interface before you run your program. You can do this in a separate shell-script, or by using the system() function from inside your program to call the gpioprogram.

Also note that some functions have no effect when using this mode as they’re not currently possible to action unless called with root privileges. (although you can use system() to callgpio to set/change modes if needed)