Use an LM317 as 0 to 3V adjustable regulator

Most engineers know that they can use an inexpensive, three-terminal adjustable regulator, such as Fairchild Semiconductor’s LM317, as an adjustable regulator to only some necessary value of voltage, such as 36 or 3V. This value cannot be less than 1.25V without employing other approaches, however. The devices’ inner reference voltage is 1.25V, and their output voltage accordingly cannot be less than this value without potential bias (Reference 1). One way to solve this problem is to use a reference-voltage source based on two diodes (Reference 2). Although this approach is suitable for a 1.2 to 15V or higher-voltage regulator, it is not appropriate for an extra-low-voltage fixed- or adjustable-voltage regulator. The two 1N4001 diodes it employs do not provide the needed potential bias of 1.2V, and they have additional temperature instability of approximately 2.5 mV/K (Reference 3). Hence, additional temperature drifting of the output voltage is approximately 100 mV; it is more than 6% for a 1.5V output voltage and 10% for a 1V output voltage if you adjust the temperature to 20°C—a typical indoor situation. You can solve these problems by using a Fairchild Semiconductor LM185 or an Analog Devices AD589 adjustable-voltage-reference IC. These devices are expensive, however, and, in this case, they require not only additional zero adjustment but also matching. These adjustments at their reference voltages are 1.215 to 1.255V and 1.2 to 1.25V for the LM185 and AD589, respectively. Note that the reference voltage of the LM317 is 1.2 to 1.3V.

 

Figure 1 This circuit is an inexpensive approach using a simple 0 to 3V adjustable regulator.

Figure 1 shows an inexpensive approach using a simple 0 to 3V adjustable regulator. You implement the necessary potential bias using a simple temperature-stabilized constant-current source (Reference 4). You calculate this current source using the following equation: I=(V_F–V_EBO)/(R₅+R₆), where V_F is D₁’s forward voltage of approximately 2V and V_EBO is Q₁’s emitter-base voltage of approximately 0.68V. The current is approximately 1.32/(R₅+R₆). The constant-current source creates a bias voltage of approximately –1.25V on resistor R₃. You implement the zero adjustment using resistor R₆, which can change the current of the constant-current source. Resistor R₅ protects transistor Q₁. You can use D₁ as a light indicator. You can adjust the output voltage using resistor R₂. Calculate the output voltage as follows: V_OUT=V_REF(1+R₂/R₁)–V_R3, where V_REF is the reference voltage of IC₁ and V_R3 is some compensative voltage of resistor R₃. You should establish this voltage to equal the reference voltage for its compensation. In this case, V_OUT=V_REF(R₂/R₁). With R₂ having a value of 1.2 kΩ,this circuit found use as the equivalent of a typical battery with an output voltage of 1.56V for development projects.