iptables

vi /etc/sysconfig/iptables
-A INPUT -m state –state NEW -m tcp -p tcp –dport 80 -j ACCEPT（允许80端口通过防火墙）
-A INPUT -m state –state NEW -m tcp -p tcp –dport 3306 -j ACCEPT（允许3306端口通过防火墙）
特别提示：很多网友把这两条规则添加到防火墙配置的最后一行，导致防火墙启动失败，正确的应该是添加到默认的22端口这条规则的下面
添加好之后防火墙规则如下所示：
######################################
# Firewall configuration written by system-config-firewall
# Manual customization of this file is not recommended.
*filter
:INPUT ACCEPT [0:0]
:FORWARD ACCEPT [0:0]
:OUTPUT ACCEPT [0:0]
-A INPUT -m state –state ESTABLISHED,RELATED -j ACCEPT
-A INPUT -p icmp -j ACCEPT
-A INPUT -i lo -j ACCEPT
-A INPUT -m state –state NEW -m tcp -p tcp –dport 22 -j ACCEPT
-A INPUT -m state –state NEW -m tcp -p tcp –dport 80 -j ACCEPT
-A INPUT -m state –state NEW -m tcp -p tcp –dport 3306 -j ACCEPT
-A INPUT -j REJECT –reject-with icmp-host-prohibited
-A FORWARD -j REJECT –reject-with icmp-host-prohibited
COMMIT
#####################################

CentOS 7.0默认使用的是firewall作为防火墙，这里改为iptables防火墙。

1、关闭firewall：

systemctl stop firewalld.service #停止firewall

systemctl disable firewalld.service #禁止firewall开机启动

2、安装iptables防火墙

yum install iptables-services #安装

vi /etc/sysconfig/iptables #编辑防火墙配置文件

# Firewall configuration written by system-config-firewall

# Manual customization of this file is not recommended.

*filter

:INPUT ACCEPT [0:0]

:FORWARD ACCEPT [0:0]

:OUTPUT ACCEPT [0:0]

-A INPUT -m state --state ESTABLISHED,RELATED -j ACCEPT

-A INPUT -p icmp -j ACCEPT

-A INPUT -i lo -j ACCEPT

-A INPUT -m state --state NEW -m tcp -p tcp --dport 22 -j ACCEPT

-A INPUT -m state --state NEW -m tcp -p tcp --dport 80 -j ACCEPT

-A INPUT -m state --state NEW -m tcp -p tcp --dport 3306 -j ACCEPT

-A INPUT -j REJECT --reject-with icmp-host-prohibited

-A FORWARD -j REJECT --reject-with icmp-host-prohibited

COMMIT

:wq! #保存退出

systemctl restart iptables.service #最后重启防火墙使配置生效

systemctl enable iptables.service #设置防火墙开机启动