ESX4 通过VMware vSphere CLI 开启snmp

发现VMware vSphere CLI的功能实在强大,学习中。。。

To configure the communities do the following:

vicfg-snmp.pl –server <hostname> –username <username> –password <password> -c <com1>.

Replace <com1> with the community name you wish to set. Each time you specify a community with this

command, the setings you specify overwrite the previous configuration. To specify multiple communities,

separate the community names with a comma.

For example, to set the communities public and internal on the host host.example.com, you might type

vicfg-snmp.pl –server host.example.com –username user –password password -c public,

internal.

vicfg-snmp.pl –server <hostname> –username <username> –password <password> -c <com1>.

Replace <com1> with the community name you wish to set. Each time you specify a community with this

command, the setings you specify overwrite the previous configuration. To specify multiple communities,

separate the community names with a comma.

For example, to set the communities public and internal on the host host.example.com, you might type

vicfg-snmp.pl –server host.example.com –username user –password password -c public, internal.

To configure the SNMP agent traps do:

vicfg-snmp.pl –server <hostname> –username <username> –password <password> -t <target

address>@<port>/<community>.

Replace <target address>, <port>, and <community> with the address of the target system, the port number

to send the traps to, and the community name, respectively. Each time you specify a target with this

command, the settings you specify overwrite all previously specified settings. To specify multiple targets,

separate them with a comma.

For example, to send SNMP traps from the host host.example.com to port 162 on target.example.com using

the public community, type

vicfg-snmp.pl –server host.example.com –username user –password password -t

target.example.com@162/public.

Enable the SNMP agent by typing

vicfg-snmp.pl –server <hostname> –username <username> –password <password> –enable.

Send a test trap to verify that the agent is configured correctly by typing

vicfg-snmp.pl –server <hostname> –username <username> –password <password> –test.

The agent sends a warmStart trap to the configured target.

To configure the SNMP agent for polling do:

vicfg-snmp.pl –server <hostname> –username <username> –password <password> -p <port>.

Replace <port> with the port for the embedded SNMP agent to use for listening for polling requests.

If the SNMP agent is not enabled, enable it by typing

vicfg-snmp.pl –server <hostname> –username <username> –password <password> –enable.

And there you have it SNMP on ESX4i.

 

本人执行以上命令后,结果如下:

Current SNMP agent settings:
Enabled  : 1
UDP port : 161

Communities :
public

Notification targets :
192.168.9.3@162/public
 

/Files/qlight/Configuring_SNMP_on_ESX4.pdf

posted @ 2010-05-04 08:57  邱亮  阅读(2176)  评论(0编辑  收藏  举报