树莓派3 启动过程分析

The boot sequence of the Raspberry Pi is basically this:

Stage 1 boot is in the on-chip ROM. Loads Stage 2 in the L2 cache
Stage 2 is bootcode.bin. Enables SDRAM and loads Stage 3
Stage 3 is loader.bin. It knows about the .elf format and loads start.elf
start.elf loads kernel.img. It then also reads config.txt, cmdline.txt and bcm2835.dtb If the dtb file exists, it is loaded at 0×100 & kernel @ 0×8000 If disable_commandline_tags is set it loads kernel @ 0×0 Otherwise it loads kernel @ 0×8000 and put ATAGS at 0×100
kernel.img is then run on the ARM.

Everything is run on the GPU until kernel.img is loaded on the ARM.

很奇怪哈，启动过程都是 GPU 在主导。