【Flash】spi-flash规范分析

一、SPI Modes

Serial Peripheral Interface Bus

• At CPOL=0 the base value of the clock is zero, i.e. the idle state is 0 and active state is 1.

For CPHA=0, data is captured on the clock's rising edge (low→high transition) and data is changed at the falling edge (high→low transition).

• At CPOL=1 the base value of the clock is one (inversion of CPOL=0), i.e. the idle state is 1 and active state is 0.

For CPHA=1, data is captured on the clock's rising edge (low→high transition) and data is changed at the falling edge (high→low transition).

 

SPI NAND supports two SPI modes:
• CPOL = 0, CPHA = 0 (Mode 0)
• CPOL = 1, CPHA = 1 (Mode 3)
Input data is latched on the rising edge of SCLK and data shifts out on the falling edge of SCLK for both modes.

Note: While CS# is HIGH, keep SCLK at VCC or GND (determined by mode 0 or mode 3). Do not toggle SCLK until CS# is driven LOW.

在CS#为高（一直保持到active-low）时，SCK即CPOL，决定了colck priority。然后在phase上是一致的，falling发出数据，rising采样。

打算采用全局变量先定义SCK的起始电平，然后1、翻转 SCK<=~SCK 来传输数据；或者 2、先falling出MSB。

 

 

 

 二、

 

 

 

//