安装整个过程比较简单。
出现的问题写一写以免以后忘记。

关于远程管理。
1在安装时需要配置一下开启远程管理（和是否开启ipv6，是否开启防火墙的是在一页的）。
2如果安装时忘记配置了。可以在Yast的network services 中 remote administration选 allow，然后按提示重新启动x服务
3GNOME中可以使用gdmsetup来配置remote服务。开启rdmcp。

关于vmware中的网卡
我是设置为bridge模式 DHCP获取ip地址。
多次尝试后，发现装了vmware tools后网卡的工作反而会不正常，network manager说没有设备。。。汗一个！


出现问题后，在YaST中设置network device-》network card。
把所有的网卡都删了。会发现有一个不能删除，只能置为未配置的状态。然后finish。
再次打开网卡配置。edit这个网卡的配置。在configure name中填入0。然后next ， finish
这是network manager开始工作。获取ip。有时候会获取到169.xxx的ip地址。
没关系，只要ifconfig eth0 down,在ifconfig eth0 up.应该就能正确获得ip。。原因位置。可能和dhcp有关


发生这种现象的原因可能是
http://www.linuxquestions.org/questions/linux-networking-3/rh9-on-vmware-eth0-no-link-present-181153/

Oh! Sorry, I was assuming your host was Linux.

I found this on VMware's site:

Getting a DHCP Address in a Red Hat Linux 9.0 Virtual Machine

When a Red Hat Linux 9.0 guest operating system tries to get a DHCP address, the attempt may fail with an error message that states the link is down. On ESX Server, this happens only if you are using the vlance driver for your network connection.

To work around this problem, become root (su -) and use a text editor to edit the following files in the guest operating system. If only one of these files exist, make the change for that file only.

/etc/sysconfig/network-scripts/ifcfg-eth[n]

/etc/sysconfig/networking/devices/ifcfg-eth[n]

In both cases, [n] is the number of the Ethernet adapter — for example, eth0.

Add the following section to each of these two files:

check_link_down () {

return 1;

}

Then run the command ifup eth[n] (where [n] is the number of the Ethernet adapter) or restart the guest operating system.

但没有去测试过这种方法。