CFX workshop - ansys

TOC

 

Virtual Classroom Session 1

    Module 1: Overview of CFD
    Lecture 1.0: Introduction to Ansys
    Lecture 1.1: Introduction to Ansys Workbench
    Lecture 1.2: Overview of CFD Process
    Demo 1: Flow in a Mixing Tee
    Workshop 1: Flow in a Mixing Tee
    Module 2: Ansys Fluid Simulation Basics
    Lecture 2.1: Ansys SpaceClaim Essentials
    Demo 2.1: Flow Distribution in an Air Manifold (SCDM)
    Lecture 2.2:Ansys Meshing Essentials
    Demo 2.2: Flow Distribution in an Air Manifold (Meshing)
    Lecture 2.3: CFX User Interface and Workflow
    Demo 2.3: Flow Distribution in an Air Manifold (CFD)
    Workshop 2: Flow Distribution in an Air Manifold

Virtual Classroom Session 2

    Module 3: Defining Fluid Simulations
    Lecture 3.1: Basic Operations in Ansys SpaceClaim
    Demo 3.1: Mixing Hot and Cold Streams in a Mixing Elbow (SCDM)
    Lecture 3.2: Global Mesh Control
    Demo 3.2: Mixing Hot and Cold Streams in a Mixing Elbow (Meshing)
    Lecture 3.3: Setting Up Physics
    Demo 3.3: Mixing Hot and Cold Streams in a Mixing Elbow (CFD)
    Workshop 3: Mixing Hot and Cold Streams in a Mixing Elbow



Virtual Classroom Session 3

    Module 4: Postprocessing Fluid Simulations
    Lecture 4.1: Geometry Handling and Repair
    Demo 4.1: Tube Bundle (SCDM)
    Lecture 4.2: Local Mesh Controls
    Demo 4.2: Tube Bundle (Meshing)
    Lecture 4.3: Postprocessing
    Demo 4.3: Tube Bundle Post-processing
    Workshop 4: Tube Bundle

Virtual Classroom Session 4

    Module 5:Parameters and Design Points
    Lecture 5.1: Main Tools, Parameters and Assemblies
    Demo 5.1: Ball Valve (SCDM)
    Lecture 5.2: Mesh Methods and Selective Meshing
    Demo 5.2: Ball Valve (Meshing)
    Lecture 5.3: Parameters and Design Points
    Demo 5.3: Parametric Study in a Ball Valve (CFX)
    Workshop 5: Parametric Study in a Ball Valve




Virtual Classroom Session 5

    Module 6: Solving
    Lecture 6: Solving
    Demo 6: Solving (Mixing Elbow and Manifold cases)
    Workshop 6: Solving (Mixing Elbow and Manifold cases)
    Module 7: Lecture 7: CFD Best Practices
    Workshop 7: Airfoil
    Module 8: Lecture 8: Turbulence
    Module 9: Lecture 9: Heat Transfer
    Workshop 8: Electronics Cooling
    Module 10: Lecture 10: Transient Flows
    Workshop 9: Vortex Shedding

https://www.ansys.com/training-center/course-catalog/fluids/ansys-cfx-getting-started#tabs__placeholder-id-3-tab