Create Stock Locator By Using API(EBS R12)

项目上对一期的采购接受接口导入程序进行更改，增加货位信息，要求：货位 = 子库存 + 项目 + 任务。由于子库启用了动态货位控制，所以需要在程序中动态创建货位，所以周折了一番。

1. 接口表: rcv_transactions_interface

字段: locator_id

API: inv_loc_wms_pub.create_locator

2. 注意点: 动态创建货位时，首先会创建货位弹性域。而创建货位弹性域时，对子库存会进行值集的验证(INV_SRS_SUBINV)，值集INV_SRS_SUBINV中，WHERE里对PROFILE.MFG_ORGANIZATION_ID做了限制，所以，在并发请求中，需要进行fnd_profile.put('MFG_ORGANIZATION_ID',111)的处理。否则会报值集验证不通过。

3. 范例脚本

DECLARE
x_return_status         VARCHAR2(1000);
x_msg_count             NUMBER;
x_msg_data              VARCHAR2(1000);
x_inventory_location_id NUMBER;
x_locator_exists        VARCHAR2(100);
BEGIN
BEGIN
    fnd_global.apps_initialize(user_id      => 1192,
                               resp_id      => 51519,
                               resp_appl_id => 211);
    fnd_profile.put('MFG_ORGANIZATION_ID',111);
END;
inv_loc_wms_pub.create_locator(x_return_status            => x_return_status,
                                 x_msg_count                => x_msg_count,
                                 x_msg_data                 => x_msg_data,
                                 x_inventory_location_id    => x_inventory_location_id,
                                 x_locator_exists           => x_locator_exists,
                                 p_organization_id          => 111,
                                 p_organization_code        => 'T01',
                                 p_concatenated_segments    => '.1995.PJ_TEST_01.1..',
                                 p_description              => NULL,
                                 p_inventory_location_type => 3,
                                 p_picking_order            => NULL,
                                 p_location_maximum_units   => NULL,
                                 p_subinventory_code        => '1115',
                                 p_location_weight_uom_code => NULL,
                                 p_max_weight               => NULL,
                                 p_volume_uom_code          => NULL,
                                 p_max_cubic_area           => NULL,
                                 p_x_coordinate             => NULL,
                                 p_y_coordinate             => NULL,
                                 p_z_coordinate             => NULL,
                                 p_physical_location_id     => NULL,
                                 p_pick_uom_code            => NULL,
                                 p_dimension_uom_code       => NULL,
                                 p_length                   => NULL,
                                 p_width                    => NULL,
                                 p_height                   => NULL,
                                 p_status_id                => 1,
                                 p_dropping_order           => NULL);