Visual Studio 2008 VSTO and InfoPath 2007 error when trying to run debug(转)

On Saturday when I was adding my finishing touches to my demo for the Philly Code Camp I ran into an error with Visual Studio 2008 VSTO and InfoPath 2007. Whenever I tried to run my InfoPath 2007 form in debug mode I got the following error.

"Microsoft Office InfoPath does not recognize some or all of the command line options. Exit and restart Microsoft Office InfoPath with the correct command line options"

When I discovered this error and found out that it happened with a brand new project my heart started to beat a little faster (ok lot faster) because I knew the pressure was on to fix the problem before my session started. I started to do searches on the internet and I couldn't find any answers and then I did one final search and I found some link that talked about a similar error with Visual Studio 2008 Beta 2 and another office application. It mentioned about updating Office 2007 with a patch to fix the error. After reading that I looked at the version I was running and notice that I wasn't running SP1 for Office 2007 and decided to install that and see if it would fix the error. Luckily I had internet access at the code camp and started the download and about 30 minutes later I got it downloaded and installed. Then I crossed all my fingers and toes and tried the debug mode again and it worked. By installing SP1 for Office 2007 fixed the problem. I'm sure there will be many more little things pop-up and if I run into them I'll be sure to post them.